Central pneumatic floor nailer manual

1. You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet on the Nailer/Stapler First, wrap the 1/4” air connector (not included) with pipe thread seal tape before connecting to a 3/8” ID Air Source Hose (not included). . tool before connecting the air sup-ply. A loose accessory may detach or break during operation. 7. Obey the manual for the air compres-sor used to power this tool. 8. Install in-line shutoff valve to allow immediate control over air supply in emergency, even if hose is ruptured. 9. Do not lay tool down until it has com-pletely stopped. Moving. Harbor Freight Tools Nail Gun Harbor Freight Tools Central Pneumatic Series 2 in 1 Flooring Cleat Staple Nailer Model Assembly and Operating Instructions. Pages:

Check your air compressor’s manual for the appropriate size cord. SKU For technical questions, please call Page 3. It is also possible that the use of an extension cord may cause your circuit breaker to trip or your panel fuse to break. Harbor Freight Tools Nail Gun Harbor Freight Tools Central Pneumatic Series 2 in 1 Flooring Cleat Staple Nailer Model Assembly and Operating Instructions. Pages: Nailer contains fasteners. c. Do not load fasteners when Nailer is connected to air hose. Always assume tool contains fasteners. Unintentional firing may occur. d. Properly adjust Nailer angle to match corresponding fasteners before inserting nail strip. Failure to do so can cause Nailer to jam and lead to personal and/or property damage. e.

View and Download Central Pneumatic set up and operating instructions manual online. 3-IN-1 FLOORING NAILER/STAPLER CLEAT STAPLE TYPE Contractor. Review of the Central pneumatic hardwood floornailer / stapler after I used it for a square foot flooring job. Watch to see the issues. 14 de set. de I bought HF Flooring Nailer Model and so far it has fired + cleats with no misfires or jambs. I contacted Harbor Freight to get.